Connecting Supply

Below you can find a step-by-step guide of how to connect and disconnect supply from a demand campaign. 

Aligning Supply

To have the supply source connected to the specific campaign, please proceed with the following steps:

When viewing a Campaign -> Click the Supply tab 

In the Supply tab you can see the list of all relevant supply that suits conditions picked in campaign settings.

The tab loads with No Data as seen here if there is no supply already connected, due to the Connection Status set to Connected.

Open

Change the Connection Status to All and then click Filter. This will now show all available supply sources that are connected and disconnected. To see only the disconnected, please select that status type.

Note the Connection Status column in the report that displays whether or not a source is connected.

Open

Each individual source can be connected by clicking the button. Any connected source can be disconnected simply by clicking the button.

Open

When connecting supply, you are asked to set the Priority Level and then you can click save to connect the source.

You do have the ability to perform the below Mass Actions by selecting multiple sources

Open